You can always find out which kernel you are running by issuing uname -r. Note: If you run a different kernel flavour, you need to install the packages corresponding to that flavour. Either continue without, or install them manually from source. Note: Not all distributions have DKMS in their repo. Additionally, installing DKMS before the GA is also recommended so you don't need to manually install the GA again after a kernel update. It's best to do a full system update and reboot before trying to install the Guest Additions. You have to make sure that the kernel-headers and/or kernel-source are of the same version as your running kernel. SuSE users need the kernel-source and kernel-syms. Kernel-devel OR kernel-pae-devel Code: Select all Expand view Collapse view yum install dkms binutils gcc make patch libgomp glibc-headers glibc-devel kernel-headers kernel-develOr alternatively:Ĭode: Select all Expand view Collapse view yum install dkms binutils gcc make patch libgomp glibc-headers glibc-devel kernel-headers kernel-pae-devel Linux-headers- (Debian) Code: Select all Expand view Collapse view apt-get install dkms build-essential linux-headers-genericCheck the version you need with uname -r.Ĭode: Select all Expand view Collapse view urpmi dkms gcc make libgomp1 glibc-devel kernel-devel kernel-headersįedora users need the following packages: For Debian and Debian based distro's like Ubuntu, you need the following packages: These packages enables you to create kernel modules. So take your time to read it all, so you understand what is happening, and more importantly, why it is needed.Īfter you have installed your Linux Guest system, there are a few additional packages needed for the Guest Additions. Skimming this howto and only execute the code blocks might not work if you don't exactly know what needs to be done or what you're doing. For Gnome, the menu is usually called Applications, but it depends on the distribution and environment (some use an image of a foot for the Gnome menu). It can be usually found in the Accessories section of the panel menu. When you use a GUI, like Gnome, a terminal should be used (but you can also drop to a virtual terminal, or TTY, by using the Host key and F2). These privileges can be obtained by logging in as root (most distributions won't allow this on the GUI, or have root disabled) or use sudo at the beginning of the command. All the commands here are run with root privileges. It would be almost impossible to write a generic, graphical installation method because of all the different graphical environments (Gnome, KDE, Xfce, IceWM, FluxBox, etc.).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |